Powersolve PAE800 Series Bedienungsanleitung PDF herunterladen

Powersolve Electronics Ltd. 8A Arnhem Road, Newbury, RG14 5RU. England

Tel: 01635 521858 Fax: 01635 523771 Email: sales@powersolve.co.uk

www.powersolve.co.uk

AC-DC Converter

Input Voltage 90-264VAC full range, 47-63Hz / 127-370VDC. Below 100VAC, derate load linearly to 90% at 90VAC.

Power Factor 0.95 at 230VAC / 0.98 at 115VAC at full load

AC Input Current (typ.) 9.3A at 100VAC / 4.7A at 230VAC

Inrush Current 30A at 115VAC / 60A at 230VAC

Leakage Current <1mA at 240VAC

Output Voltage See Table

Output Current See Table

Voltage Tolerance ±2%

Voltage Adjust Range ±5.0% typical adjustment by potentiometer

Overload Protection >105% of rated output power. Protection type: Constant current limiting

Overvoltage Protection Variable OVP, 125% ±7% of Vout. Output latches off, recycle AC input to recover or inhibit

Over Temperature Protection Shuts down output, recovers automatically (85°C ±5°C detect on heatsink on secondary side)

Auxiliary Power +5V/0.5A or +8V/0.3A auxiliary output selected by user

Remote ON/OFF Control External switch or NPN transistor to turn on/off

Power OK Signal Open drain signal low when PSU turns on. Max. sink current 20mA, max drain voltage 40V

Output Voltage Programming Adjustment of output voltage between 0-105% of rated output

Output Current Programming Adjustment of output current between 0-105% of rated output

Operating Temperature Range -20°C to +60°C. Above 50°C, derate linearly to 60% load at 60°C

Operating Humidity 20-90% RH non-condensing

Storage Temperature Range -40°C to +85°C

Storage Humidity 10-95% RH non-condensing

Temperature Coefficient ±0.02%/°C (0-50°C)

Vibration Compliance to IEC68-2-6, IEC68-2-64

Safety Standards UL60950-1 2nd edition, TUV EN60950-1: 2006+A11 approved

Withstand Voltage I/P-O/P: 3KVAC, I/P-FG: 1.5KVAC, O/P-FG: 0.5KVAC

Isolation Resistance I/P-O/P, I/P-FG, O/P-FG: 100MΩ / 500VDC

EMI Conduction & Radiation EN55022: 2006+A1: 2007 Class B, EN61204-3: 2000, EN61000-6-3: 2007

Harmonic Current EN61000-3-2: 2006+A2: 2009 Class A, EN61000-3-3 : 2008

EMS Immunity EN55024 : 1998+A1: 2001+A2 : 2003 light industry level criteria A, EN61204-3: 2000, EN61000-6-1: 2007

Cooling Internal fan controlled by power rating & temperature, allow 50mm clearance at each end for airflow

Dimensions 249(L) x 127(W) x 41(H) mm

Weight 1.7Kg

Electrical Specification

Notes:

1. All parameters NOT specifically mentioned are measured at 230Vac input, rated load and 25°C ambient temperature

2. Ripple and noise are measured at 20MHz bandwidth by using a 12” twisted pair wire terminated with a 0.1µF ceramic & 47µF electrolytic capacitors across the output

3. Derating is required at low input voltages. Below 100Vac, derate linearly to 90% load at 90Vac

4. When parallel connected, only one unit may operate if the total output load is less than 5% of rated load

5. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC Directives

PAE800 Series

800W Active PFC

Single Output

Features

• Universal AC Input with active PFC

• Programmable Output Voltage (0%-105%)

• Programmable Output Current (0%-105%)

• High Efficiency up to 93%

• +5V/0.5A or +8V/0.3A Auxiliary Output

• Intelligent LED Indicators

• 1U profile, High Power Density

• Forced current sharing for parallel operation

• Power OK signal (Power good, logic low)

• Remote ON/OFF, Remote Sense function

• OVP, OLP, OTP, SCP, Fan Failure Protections

• Constant Current Limiting

• Optional RS232 Function

• Built-in I

C Serial Data Bus

1 2 3 4 5 6

AC-DC Converter 1